Supply your domestic hot water and heating requirements with the SunnyLine solar thermal collector. Available in 2 sizes to suit a wide variety of properties, these slim line solar panels include a 10 year guarantee for longevity. Reduce your energy costs and improve your home's efficiency with SunnyLine solar thermal collectors!
SunnyLine Solar Thermal Collectors overview
Suitable for a wide range of applications
For vertical or horizontal installation
Available in two sizes:
Large format: 2,400 x 1,155 x 85 mm
Aperture area 2.5 m²
Small format: 1,785 x 1,155 x 85 mm
Aperture area 1.82 m²
Why the structure of the collector should be important to you: because environmental influences such as wind, rain, dirt, UV radiation, snow loads and extreme variations in temperature are active on the collector over a period of decades.
Collector tray - the 'foundation'
The welded tight aluminium tank forms the “foundation”.
The high quality manufacturing process protects the inside of the collector for decades.
Absorber – the 'heart' of the collector
The highly selective solid surfaced absorber (blue-line) stands out for its level of solar absorption of approx. 95% and level of heat emission of approx. 5%.
The absorber unit which is fitted so it floats (ultrasound-welded blue-line absorber strip and copper heat-carrying pipe) guarantees the maximum energy useage.
The solar safety glass
4 mm of solar safety glass with prismatic structure and low lead content
Maximum transparency to light. Impact and hailstone resistant.
Special seal – robot-produced
Special UV-protection seal with permanent elasticity.
Joins the tray, glass and beaded edge .
Prevents penetration of humidity and dirt.
Aluminium glass holding strip
Special anodised aluminium profile.
No rubber seals, with a UV-radiation and weather resistant aluminium profile that efficiently protects the glass edges.
Guarantees a long-lasting join between the tray and the glass.
1/2” external thread with butt joint.
The surface joints located on the inside and outside of the tray are screwed down parallel to the casing with brass bolts, in such a way that they hermetically seal the tray.
No rubber or plastic seals that wear out in outdoor conditions.
Single connection of the collector pipes.
Rear wall insulation
50 mm of mineral wool with low binding content.
As a result of the low proportion of binding agents that exist in the mineral wool insulation releases almost “zero gases”.
The ring-groove ventilation is located on the collector’s distribution pipe.
Makes it easy to ventilate solar collectors connected in series.
A picture is worth a thousand words
Schematic diagram of the Sunnyline collector
1. Collector tray - the 'foundation'
2. Absorber – the 'heart' of the collector
3. Solar safety glass
4. Special seal - robot produced